MODEL PROFILE
Signal or code
Error codes and display signals
The official manual linked for this model documents these messages. Some indicators apply only to variants that display them; each entry is labeled as a code, indicator, or status.
No matching signal for this model.
Model and error-code facts may be shown in the language of the original source.
Official PDF manual
Jump to manual pages
Open the official PDF at pages that document signals for this model.
MODEL OVERVIEW
About this model: GE PSI23NCPBB
Black 22.6-cu-ft PSI23NCPBB: digital CustomCool non-dispenser with a blinking green icemaker jam signal.
A digital 23-size Profile without dispenser
PSI23NCPBB is a black GE Profile CustomStyle side-by-side with 22.6 cubic feet of stated capacity. GE lists 14.38 cubic feet for fresh food and 8.19 for frozen storage. Its exact page makes two hardware points that must be read together: the icemaker is factory-installed, while the front is explicitly Non-Dispenser. Ice is made within the freezer; there is no door pad to serve water or cubes. The product instead emphasizes an upfront digital temperature display, Turbo Cool, electronic sensors, Air Tower and Multiflow management. Another distinctive part is the bottom CustomCool drawer on full-extension slides. GE's exact specification gives all three modes, Express Chill, Express Thaw and Select Temp. The linked owner guide is a common Profile side-by-side manual covering sizes 23, 25, 26, 27 and 29, so its illustrated front-dispenser options are not automatically features of this reference. The verified green warning belongs to the installed icemaker rather than the large digital temperature or CustomCool readouts.
What the green icemaker blink means
Page thirty-six of the troubleshooting table says a blinking green power light on the icemaker means cubes stuck inside it. Rendered page fourteen draws a single ice-making unit with a switch, green lamp and feeler arm; the exact product confirms ice hardware from the factory. Turn the icemaker off, free the trapped cubes and switch it on again as the table directs. That is a local mechanical obstruction, not a freezer-temperature number or a countdown on the CustomCool drawer. The same table separates an ice switch left off, disconnected water, a warm freezer and cubes heaped high enough to lift the feeler arm. Level the heap if it is the cause; do not call it the blinking internal jam unless the lamp actually flashes. The manual allows twelve to twenty-four hours before initial cubes after installation. Page fourteen also has a special side column about a tilt-out bin for dispenser models. PSI23NCPBB has no dispenser, so its optional front-bin steps do not describe this exact unit. Observe the green lamp at the mechanism and note its switch and water state before asking for service.
Three genuine CustomCool modes
CustomCool can look like an alert even when working normally. Rendered page seven matches the exact product's ExpressThaw, ExpressChill and SelectTemp modes. GE instructs emptying the pan, placing food on the Chill/Thaw tray and closing the drawer before selecting a program. A SET light and changing time display accompany the selection; ExpressThaw and ExpressChill count down while running. After ExpressThaw, the drawer returns to the MEAT setting at 32°F, according to the manual. Those states are ordinary drawer operation and should not be renamed fault codes. The precise product has an in-door beverage rack, but the family guide also shows a separate optional Beverage Center pad. Its presence is not confirmed for PSI23NCPBB, so there is no reason to assign that extra control. Full-extension slides let the bottom drawer pull out farther for loading; the CustomCool panel operates that sealed pan, not the icemaker. If an ice lamp blinks during a thaw program, inspect the ice unit independently rather than cancelling a normal drawer cycle as a supposed ice remedy.
Temperature readout and storage layout
For daily use, the digital temperature controls begin at 37°F in fresh food and 0°F in the freezer. The guide distinguishes a requested SET value from actual compartment temperature and allows 24 hours after a change before assessment. OFF on either temperature control stops cooling both areas without disconnecting electric power. TurboCool is a temporary fresh-food cooling program, not a sign that the green icemaker lamp is healthy or faulty. This model lists three fresh-food cabinet shelves with a QuickSpace half-shelf and two slide-out spillproof glass shelves. In the freezer are two wire cabinet shelves, one sliding, and four baskets, three on full-extension slides, plus four tilt-out door bins. Push sliding shelves or baskets back before shutting the door so packages do not prevent closure. If blinking continues after clearing ice, report PSI23NCPBB, ice switch position, water connection, actual trapped or piled cubes and time since installation. Keep family-only dispenser, filter-light and door-alarm buttons out of that report; this exact GE product has no front dispenser.
Verified model details
Exact GE SKU confirms all three CustomCool modes and factory ice.
Source for this detailRendered p36 links blinking green icemaker lamp to stuck cubes.
Source for this detail · Source page: 36
This description summarizes the linked source documents; check each cited source for your exact model and region.
Manufacturer source
Open official source
GE Profile CustomStyle™ 22.6 Cu. Ft. Side-by-Side Refrigerator - PSI23NCPBB - GE Appliances
Open official sourceIf there is a safety risk, stop using the appliance and follow the manufacturer’s instructions.