MODEL PROFILE
Signal or code
Error codes and display signals
The official manual linked for this model documents these messages. Some indicators apply only to variants that display them; each entry is labeled as a code, indicator, or status.
No matching signal for this model.
Model and error-code facts may be shown in the language of the original source.
Official PDF manual
Jump to manual pages
Open the official PDF at pages that document signals for this model.
MODEL OVERVIEW
About this model: GE DPSB619EDCC
Bisque electric DPSB619 One Touch and its end-cycle filter reminder.
Exact model and panel
DPSB619EDCC is a GE One Touch electric dryer finished bisque on bisque, with a 7.0 cubic foot stainless steel drum. The exact GE specification gives a 27 inch width, 28 1/4 inch depth and 42 inch height; it also lists Sensor Dry Plus, a cycle countdown, Delay Start and a deluxe dryer rack. In the owner PDF linked from this retail SKU, page six contains separate drawings for DPSB613 and DPSB619. The lower drawing is explicitly labeled DPSB619 and has a CLEAN LINT FILTER cycle status lamp beneath its One Touch selections. This exact panel matters because the sibling DPSB613 has a different arrangement of some drying controls. The product page identifies this unit as electric and bisque, while the family manual explains the lamp and buttons. Reading both together avoids copying a gas installation claim or a control feature from the wrong illustrated panel.
What the indicator means
Page twelve defines what the CLEAN LINT FILTER lamp does on this family. It comes on at the end of a cycle to remind the owner to clean the screen, and it goes off when the door is opened. It does not illuminate because the dryer measured a specific amount of lint or a blocked exhaust duct. Open the door, remove and clean the lint filter, put it back and prepare the next load. The lamp turning off at door opening is the documented behavior, not proof that opening automatically cleaned the screen. Equally, an unlit lamp before a load is not permission to leave lint in place. The safety page asks for the filter to be cleaned before each load. If the dryer later takes too long, check actual filter condition, loading and venting rather than diagnosing a heater error from this reminder. No numeric failure code accompanies the lamp in the guide.
Cycles and practical use
The DPSB619 panel makes the model more than a filter notice. Its One Touch cycles select a starting dryness and heat level; Sensor Dry Plus monitors load moisture and can stop when the selected level is reached. The exact product page adds a variable damp dry signal that can alert you before everything is completely dry, useful when setting aside items for ironing. A Delay Start is also listed, but delaying a load does not change the need to clean the screen first. GE identifies a Warm Up cycle and a deluxe dryer rack, both of which serve different use cases from ordinary tumbling. The rack is for items the guide permits to dry without the usual movement; confirm the cycle and fabric care instructions before using it. A cycle countdown, sensing light, damp signal and end-cycle filter lamp each communicate a different stage or choice.
Care and a focused check
The compact 28 1/4 inch cabinet depth can help fit a laundry area, but leave the exhaust route and clearances required by the linked electric installation instructions. The stainless drum handles everyday loads, yet packing 7.0 cubic feet tightly can prevent even exposure to air. If drying performance changes, note whether a One Touch sensor program or timed setting was selected, whether the damp signal sounded, and whether the filter lamp appeared at the end. Then open the door and actually clean the screen; look at the exhaust path if later loads still remain wet. The correct sequence is tied to the lamp's documented end-of-cycle timing, not to the POWER-to-START reminder used on another GE family. This difference makes the DPSB619EDCC article useful for owners who see the light after a load and wonder whether a fault has been detected.
Verified model details
Rendered p6 identifies the DPSB619 One Touch panel.
Source for this detailCLEAN LINT FILTER lights at cycle end and goes out when the door opens.
Source for this detail · Source page: 12
This description summarizes the linked source documents; check each cited source for your exact model and region.
Manufacturer source
Open official source
GE Profile™ 7.0 Cu. Ft. Super Capacity Electric Dryer with Stainless Steel Drum - DPSB619EDCC - GE Appliances
Open official sourceIf there is a safety risk, stop using the appliance and follow the manufacturer’s instructions.