AppliClue
ENESFRDE

MODEL PROFILE

Dishwasher / Bosch

SHP78CM2N

Find the official source for this exact appliance model.

Signal or code

Error codes and display signals

The official manual linked for this model documents these messages. Some indicators apply only to variants that display them; each entry is labeled as a code, indicator, or status.

E:20-60Error codeThe appliance detected limescale on the heating element.E:21-30Error codeDishware blocks the intake opening of the Zeolite container.E:30-00Error codeThe water protection system is active.E:31-00Error codeThe water protection system is active.E:32-00Error codeA water inlet problem: the supply valve may be closed or clogged, or the inlet hose may be blocked.E:34-00Error codeWater keeps entering the appliance.E:61-02Error codeThe drain pump cover is loose or a foreign object blocks the pump.E:61-03Error codeWater is not draining; the disposal plug, drain hose, pump cover, or drain-hose high loop may be involved.E:61-60Error codeThe dishwasher has a technical fault.E:90-01Error codeThe supply voltage is too low; Bosch says this is not an appliance fault.E:92-10Error codeThe lower spray arm cannot rotate or is not fitted correctly.E:92-40Error codeThe filters are dirty or blocked.

Model and error-code facts may be shown in the language of the original source.

Official PDF manual

Jump to manual pages

Open the official PDF at pages that document signals for this model.

Source page 38E:20-60, E:21-30, E:30-00, E:31-00, E:32-00Source page 39E:34-00, E:61-02, E:61-03, E:61-60Source page 40E:90-01, E:92-10, E:92-40

MODEL OVERVIEW

About this model: Bosch SHP78CM2N

The Bosch SHP78CM2N is an 800 Series 24-inch dishwasher with top controls and a white finish, specified for 16 place settings at 42 dBA. Its listed programs include Heavy, Auto and Normal, with Sanitize and Crystal Dry among the available options. PrecisionWash with the PowerControl spray arm and selectable ZoneControl regions provide its wash setup; Bosch lists CrystalDry for drying.

Fit and installation

Its exterior is listed as white, with a pocket handle design. This is the version to compare with a replacement if visible finish and door grip matter. Bosch gives body dimensions of 33 7/8 x 23 9/16 x 23 3/4 inches, in height-width-depth order, and a required opening of 33 7/8 in x 24 in x 24 in. Measure the opening and consult the installation instructions; the cutout and appliance measurements serve different purposes. The product details state all feet adjustable from the front. Leveling access is therefore an installation question to check in the actual kitchen, not a wash-cycle feature.

Source for this detail · bosch-home.com

Program choices

A practical way to read the SHP78CM2N program list is to begin with the load rather than the series badge. Bosch names Heavy, Auto, Normal, Speed 60, Favorite for this SKU. Choose among those actual entries, then use a compatible option if the controls offer it; a program visible only in Home Connect belongs to a different menu. Favorite can preserve a chosen combination after setup. The product sheet does not establish that a shorter-named program will suit every load or eliminate the need to arrange dishes correctly. On this exact listing, Auto is an appliance program while Energy Save is in the Home Connect-only list. Keep those access routes separate when a household expects a control to be on the physical selector.

Source for this detail · bosch-home.com

Model configuration

Bosch lists SHP78CM2N as a 800 Series built-in dishwasher with room for 16 place settings and a published 42 dBA sound rating. The model number matters when reading support material: similarly named units can have different door treatments, program menus or indicators. Sanitize appears in the published option list, whereas Energy Save is identified with the connected menu. An option can depend on the selected program; the specification alone does not prove every combination is available.

Source for this detail · bosch-home.com

Drying and controls

Bosch lists an audible end-of-program signal for SHP78CM2N. Listen for completion before judging a damp load or opening the door to unload; the sound is an operating cue, whereas a displayed fault or unusual LED pattern belongs to the manual’s diagnostic table. Home Connect can show progress after setup, but it does not identify the cause of a blocked drain or closed supply valve. Use the exact control layout and the cited instructions for a real warning. Bosch lists Crystal Dry among the controls and CrystalDry, PureDry as the installed drying system. If Auto finishes with water in concave pieces, check the selected drying option and rinse-aid guidance before assuming a defect.

Source for this detail · bosch-home.com

Reading the manual diagnostics

The linked manual for SHP78CM2N gives individual alphanumeric faults rather than a single generic 'dishwasher error.' E:30-00 and E:31-00 concern active water protection and call for closing the water valve and contacting Bosch. E:32-00 instead points to the inlet path, such as a closed valve or kinked hose; E:34-00 describes water continuing to enter. These similar-looking numbers lead to different checks, so read the full characters on the display before taking action. A further exact-manual example is E:21-30: it describes dishes covering the Zeolite intake; rearrange them to clear that opening. This is a different subsystem from the other codes above, so record the complete display before choosing an owner-level check.

Source for this detail · media3.bsh-group.com · Source page: 38Source for this detail · media3.bsh-group.com · Source page: 39Source for this detail · media3.bsh-group.com · Source page: 40

Verified model details

This description summarizes the linked source documents; check each cited source for your exact model and region.

Manufacturer source

Open official source

Official source linked

Bosch SHP78CM2N dishwasher product page and manuals

Open official source

If there is a safety risk, stop using the appliance and follow the manufacturer’s instructions.

← Back to all models